MP5 Clone Issues

From Thinline Weapons Wiki
Jump to navigation Jump to search

PTR

  • PTR9C is a huge disappointment
    • The safety is way to lose. It moves up and down very, very easily. Almost freely. Looks like the safety itself is too long, and where the left side lever is connected to the safety bar protrudes too far from the housing to give adequate “grip”.
    • My HKPDW brace doesn’t fit. The rear of the receiver is too wide at the top to clear the cap. It’s scratching my receiver all to hell trying to fit it, and now I’m going to try dremeling down the inside of the braces cap a bit.
    • The charging handle is loose in the upper and rattles, and moves freely back and forth about 1/4”.
    • The 3-lug is too long and won’t allow attachment of my SilencerCo 3-lug on any suppressor I try.
    • A large scratch immediately developed on the bolt after charging it a few times. Granted this area would probably get scratched up eventually anyway, but a scratch this large leads me to believe there is a bur in the chamber.

POF/FedArm

MKE/Zenith